Installing and setting up the Ecobee3 smart thermostat

Ecobee3 is a smart thermostat that’s not owned by a data-collection giant, and has extra sensors for extra functionality.

Our friends at Android Central recently took a deeper look at Google’s Nest, so we thought we’d do the same thing with the Ecobee3, which as thermostats go, might be even smarter. And we’re starting with a hands-on install!

Step 1: Disconnecting the dumb

Right from the start, Ecobee did a good job with the instructions. They made the process seem simple, which took a lot of the stress out of something that could otherwise seem like a major change to your home.

First, we went into the garage to power off the HVAC system (heating, ventilation, and air conditioning). A couple of switches later, and we were ready to go. That meant taking the cover off the old thermostat.

The next step was the most daunting: We had to label all the wires. Ecobee provided stickers to make it easier, but it was slow going just because none of us had ever done anything like that before. For example, there was a warning about high voltage systems, which we didn’t really understand. So, we ignored it and proceeded anyway. It turned out fine, but some extra help here would have been appreciated.

Form there we followed the instructions carefully — we matched the wires from our old thermostat to the stickers Ecobee provided. Because we had the wire labeled “C”, we got to skip ahead. If we hadn’t, we’d have had to install the power extender kit as well.

Step 2: Setting up the smart

Attaching the back wall plate was also easy, but it wasn’t obvious. There were only two sizes, but one was already attached to the unit and we didn’t realize it. Once we figured that out, it was simple to install. Ecobee3 even comes with a level, which is great, because it makes it easy to keep it straight.

Because the old thermostat was a horizontal rounded rectangle, and the Ecobee3 is a circle, they don’t cover the same wall area. That means Georgia has an excuse to will need to repaint.

Reconnecting the wires proved to be the biggest challenge. We couldn’t figure out from the directions how to match them back up. So, we called Ecobee support. Even though it was a weekend, they answered quickly. While we were initially told we’d have to wait for a customer service rep, the rep answered almost immediately.

Once we started talking, the rep asked a few questions, which we answered, and then he told us exactly how to proceed. That level of support is impressive!

Next we plugged in the actual Ecobee3 unit, then went down to the garage to turn the HVAC system back on. The Ecobee screen lit up right away with instructions on what to do next. We followed along to set up WI-Fi, to register online with the provided code, and to get everything up and running. Much of it was done right on the Ecobee3 touch screen, which was great. The registration was done on the iPhone, which was also great.

The remote sensor was even easier. We removed the battery sticker and it paired immediately. The we placed it, as recommended, in a high traffic area.

Step 3: Climate controlled!

The entire Ecobee3 installation and setup was faster and easier than we expected, and now we’re happily testing the smart thermostat on both our iPhones and Apple Watches.

That will be the subject of our next installments!

Source: iMore

About Bhavesh Rabari

Check Also

EE Offers First Plan Bundling Apple Subscription Services in the UK

UK carrier EE has launched a new package called the “Full Works” plan for iPhone, …

Leave a Reply

Your email address will not be published.